2013-2016 Toyota 4 Runner Fuse Box Interior Exterior Diagram

Toyota 4Runner Electrical Fuses Replacement Guide
How to check or change a blown electrical fuse or relay in a 5th generation 2010-2016 Toyota 4Runner with photos.

2015 4Runner Fuse Box
Push In Tab To Release Cover
Remove Fuse Box Cover This automotive maintenance tutorial was specifically written to assist owners of the fifth generation (2010, 2011, 2012, 2013, 2014, 2015 & 2016) Toyota 4Runner SUV in checking or changing a blown fuse or relay in either the engine bay or the interior passenger compartment electrical panels.

Owners of other Toyota, Lexus or Scion vehicles such as the Yaris, Corolla, Matrix, Prius, Camry, RAV4, Sienna, Tacoma, Tundra, FJ Cruiser, Venza, Highlander, Avalon, Sequoia, Land Cruiser, IS 250, ES 350, GS 350, tC, xB, xD, iQ and FR-S may also find these DIY instructions to be helpful.

This 2015 Toyota 4Runner was equipped with the relatively newer style of low profile mini blade fuses which can be purchased at Amazon.

A white plastic fuse puller tool should be included on the engine bay electrical block.

Fuse Location Diagram
Engine Bay Fuse Panel
White Plastic Fuse Puller Tool The first two steps are to open the hood and then move to the right side of the engine bay.

The engine bay fuse box is located right behind the 12V car battery and in front of the brake fluid reservoir.

Gently push in the plastic tab on the rear edge of the fuse box cover before pulling it straight off.

Turn over the fuse box cover to view the fuse location diagram. There is also another fuse location diagram in the owner's manual.

Remove the white plastic fuse puller tool from its socket located near the front middle of the engine bay fuse block.

Driver Side Dashboard
Look Under Dashboard
Interior Fuse Panel Cover The interior passenger compartment electrical panel is located under the driver side of the dashboard close to where the driver's left knee would normally reside while driving.

Look under the dashboard and locate the white plastic rectangular shaped fuse panel cover.

Pull Off Plastic Cover
Fuse Location Diagram
Interior Fuse Block Gently pull the plastic cover off the interior fuse panel.

There is a fuse location diagram on the outside of the cover. Another location diagram is in your owner's manual.

Place Jaws Over Old Fuse
Pull Out Old Fuse
Hold Up To Light Bulb Squeeze the end of the white plastic fuse puller tool to open the jaws.

Place the jaws over the old fuse that you'd like to check or change.

Pull the old fuse straight out of the socket.

Check the condition of the old fuse by holding it up to a light bulb.

If the thin metal band inside the middle of the old fuse appears to be intact, the old fuse is most likely still good.

But since new fuses are so inexpensive, it should still be replaced as part of your electrical problem troubleshooting process.

If the thin metal strip in the translucent plastic center of the old fuse appears to be burnt or broken, the old fuse is faulty or "blown" and should be replaced with a new fuse.

Push In New Low Profile Fuse
Replace Fuse Puller Tool
Replace Interior Fuse Cover Push a new low profile mini blade fuse of the same amperage rating (5, 10, 15, 20, 25A, e.g.) straight in to the socket.

The older 4Runner model might be equipped with the slightly taller standard mini blade fuses.

If you suspect that a relay is faulty, the easiest way to troubleshoot the problem is to simply replace the relay. You could also test the old relay with a multimeter tool.

If necessary, you can use mini blade fuses instead of the low profile fuses. The standard mini blade fuses will just stick out of the socket a bit.

Replace the white plastic fuse puller tool in to its socket at the front edge of the engine bay fuse panel.

Engine Bay Fuse Box Cover
Push On Fuse Box Cover
Electrical Fuse Replaced Push the interior fuse panel cover back in to place.

Lower the engine bay fuse cover back in to place and push on it to secure the retaining clip.

Test the electrical component that you were having problems with such as the radio, power windows, interior lights, headlights, tail lights, horn, A/C system, wiper blades, etc.

If you are still having the same problem, there might be a shorted wire somewhere or the component itself needs to be replaced.

Be sure to record the fuse or relay change in your vehicle's service records.

For more, check out my other 2010-2016 Toyota 4Runner DIY Repair & Maintenance Guides.

Posted by: ernestnhepssa.blogspot.com

Source: https://paulstravelpictures.com/2010-2016-Toyota-4Runner-Electrical-Fuse-Replacement-Guide/